François
3aad5e2308
One clock knob across probes instead of per-driver names: - jtag_open mirrors JTAG_TCK_FREQ_KHZ into PROBE_FTDI_TCK_FREQ_KHZ for the Viveris FTDI driver (read-only at init); unset leaves the existing value untouched - the Digilent driver reads JTAG_TCK_FREQ_KHZ directly instead of hardcoding 4 MHz (falls back to 4 MHz when unset) - documented in probes.yaml; CLAUDE.md design note marks phase A done FTDI path validated on the IGLOO2/FlashPro (250 kHz, mirror confirmed); Digilent path not hardware-tested. Co-Authored-By: Claude Opus 4.7 <noreply@anthropic.com>
32 lines
1.3 KiB
YAML
32 lines
1.3 KiB
YAML
# bs_explorer probe-config profiles
|
|
#
|
|
# Loaded at runtime by modules/probes/, layered on top of the built-in
|
|
# config.script defaults. Looked up CWD-relative (run from the repo
|
|
# root), or via $BS_PROBES.
|
|
#
|
|
# defaults: applied on every `jtag_open` (restores a known baseline
|
|
# so opening without a profile is deterministic).
|
|
# profiles: named override sets; select with `jtag_open <idx> <name>`.
|
|
#
|
|
# Each key is a probe variable (see modules/config/config.script for the
|
|
# full list); each value is what `set <KEY> <value>` would assign.
|
|
|
|
defaults:
|
|
# Baseline for a standalone FT2232H JTAG probe: drive ADBUS4 as the
|
|
# "JTAG buffer enable" output (matches the built-in default).
|
|
PROBE_FTDI_SET_PIN_DIR_ADBUS4: 1
|
|
# Driver-neutral JTAG clock in kHz. Honoured by the FTDI driver (mapped
|
|
# to PROBE_FTDI_TCK_FREQ_KHZ at open) and our Digilent driver. Leave it
|
|
# out to keep each driver's own default (FTDI 1000, Digilent 4000).
|
|
# JTAG_TCK_FREQ_KHZ: 1000
|
|
|
|
profiles:
|
|
# Embedded FlashPro on Microsemi eval kits (FT4232H, JTAG on channel A
|
|
# = probe index 0). Its ADBUS4 must be left high-Z or the chain stays
|
|
# silent. Usage: jtag_open 0 flashpro
|
|
flashpro:
|
|
PROBE_FTDI_SET_PIN_DIR_ADBUS4: 0
|
|
|
|
# Plain FT2232H probe: nothing to override beyond the defaults.
|
|
ft2232h: {}
|